Fujitsu Eternus DX90 S2 - Page 9

9
ETERNUS DX80 S2/DX90 S2 Disk storage system Read Me First
Copyright 2013 FUJITSU LIMITED
P3AM-4872-11EN
M5 screws
M5 screws
Flange cover
Flange cover
3.
Install the controller enclosure or the drive enclosure in the rack.
4.
Fasten the controller enclosure or the drive enclosure in the rack.
Use four M5 screws to fasten the controller enclosure or the drive enclosure to the rack pillars and attach the
flange cover.
5.
Attach the brackets to the rack rails (for the left and right sides).
Use the thumb screws to attach the brackets at the specified locations on the rear side.
2.5" controller
enclosure
Attachment location of the bracket
3.5" controller
enclosure
2.5" drive
enclosure
3.5" drive
enclosure
Bracket
Thumb screw
Left Right
3.5" controller
enclosure
2.5" controller
enclosure
3.5" drive
enclosure
2.5" drive
enclosure
Make sure to install or remove the controller enclosure or the drive enclosure to or from a rack with two or
more people.
IMPORTANT