Fujitsu fi-65F - Page 5

5
3. Connect the power cable or USB bus
power cable.
zFor the power cable connection
The AC cable and AC adapter connected to
each other are collectively called the "power
cable".
Connect the power cable to the power
connector of the scanner, and plug the other
end into an AC outlet.
zFor the USB bus power cable
Connect the USB bus power cable to the
power connector of the scanner and to the
USB port of the computer.
Test-Scan
Follow the procedure described below to check
that documents can be scanned correctly by using
PaperStream Capture and the PaperStream IP
(TWAIN) driver.
1. Turn on the computer.
D The scanner is turned on, and the power
LED lights in green.
D The scanner is automatically recognized
by the computer.
2. Place a document on the scanner.
1. Open the document cover.
2. Place the document on the document bed.
Place the document face-down to align its
top left-hand corner with the reference point.
3. Gently close the document cover.
WARNING
Only use the power cable or USB bus
power cable that is supplied with the
scanner.
Doing the following may cause an electric
shock or the scanner to malfunction:
zUsing a power cable or USB bus power
cable that is not supplied with the
scanner.
zUsing the supplied power cable or USB
bus power cable with other products.
ATTENTION
If the power LED does not light in green,
refer to "Chapter 6 Troubleshooting" in the
Operator's Guide.
Power LED
HINT
When the [Found New Hardware] dialog
box appears, click [Locate and install driver
software (recommended)] and then follow
the instructions on the screen to proceed
with the installation.
Document cover
ABC
ABC
Reference point
Document bed
ABC
Document
cover