EasyManua.ls Logo

Fujitsu fi-6800 - Introduction; About This Product; Manuals

Fujitsu fi-6800
26 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
fi-6800 CONSUMABLE REPLACEMENT AND CLEANING INSTRUCTIONS
REPLACING THE PICK ROLLERS
Worn, defective, or improperly installed Pick Rollers will cause misfeeds
and paper jams. The Pick Rollers have an approximate life of 600,000
pages. If NCR or carbonless paper is used the life span of the Pick
Rollers may be decreased by half.
Tab
Roller Cover
Pick Roller
Make sure there is no paper
in the stacker.
Grab the ADF Release Tab
and lift it up to open the ADF.
Note:
When you stop pushing up on the ADF it stays at that location.
Open the Roller Cover by
grabbing the tabs on the left
and right sides with your
fingers and pull down.
Pull out on the tab that locks
the Pick Roller in place in
the direction of the arrow and
slide the Pick Roller off the
shaft.
Repeat the procedure above
to remove the second Pick
Roller.
Note:
The roller shaft and the hole in the Pick Rollers are keyed and will only
slide on in one orientation.
Install the new Pick Rollers
by aligning the hole in the
rollers with the roller shaft.

Other manuals for Fujitsu fi-6800

Related product manuals