Fujitsu FTP-638WSL110 Series User Manual

2 Operating Procedures
26
2.4 Printer Error
The error occurs when the printer cannot print/work normally. The
type of error is shown by the LED when the error is occurring.
Please reset the status when the error occurs.
The following example explains reasons and solutions for problems.
Error
Cause
Solution
Paper End
- There is no paper
in the paper cover.
- It is not correctly set
though there is paper
- Particles have
collected on the paper
sensor.
- Please correctly set
the paper,
refer to chapter 1.5.
- Please clean the paper
sensor,
refer to chapter 4.3.
Paper Cover
Open
- The paper cover is
open.
- Please correctly
close the paper
cover,
refer to chapter 1.5
Thermal Head
Temperature
Error
- The thermal head is too
hot.
- Please do not print for a
while.
Once the thermal head
cools down, the error
disappears.
Important
- It is normal that the temperature goes up because this printer prints by
heating the thermal head.
- The Thermal Head Temperature Error is generated easily by the high
ambient temperature.

Fujitsu FTP-638WSL110 Series Specifications

General

Brand	Fujitsu
Model	FTP-638WSL110 Series
Category	Printer
Language	English