To Next PageTo Next PageWhat to do if my Fujitsu Inverter 9316796003-01 Air Conditioner doesn't operate at all?
If your Fujitsu Air Conditioner doesn't operate at all, first check for a power failure. Next, verify whether a fuse has blown or a circuit breaker has tripped. Finally, check if the timer is operating.
Why is water produced from the outdoor unit of my Fujitsu Air Conditioner?
During Heating operation, water may be produced from the outdoor unit due to Automatic Defrosting operation.
How to fix a Fujitsu Inverter 9316796003-01 that doesn't operate immediately?
If the unit is stopped and then immediately started again, the compressor will not operate for about 3 minutes to prevent fuse blowouts. Also, whenever the electrical breaker is turned off then on again or the power supply plug is disconnected and then reconnected, the protection circuit will operate for about 3 minutes, preventing unit operation during that period.
What to do if my Fujitsu Inverter 9316796003-01 Air Conditioner operates differently from the Remote Control Unit’s setting?
If your Fujitsu Air Conditioner unit operates differently from the Remote Control Unit’s setting, check if the Remote Control Unit’s batteries are dead or if the Remote Control Unit’s batteries are loaded properly.
Why is my Fujitsu Inverter 9316796003-01 Air Conditioner performing poorly?
Poor performance of your Fujitsu Air Conditioner can stem from several factors. Check if the air filter is dirty or if the unit's intake grille or outlet port is blocked. Ensure the thermostat settings are correct. Closing any open windows or doors can help, as well as drawing curtains to block direct sunlight during Cooling operation. Also, consider whether there are too many heat-generating devices or people in the room. Ensure that the lower air outlet is not obstructed and that the unit is not set to SUPER QUIET operation.
Why is the airflow weak or stopped in my Fujitsu Air Conditioner?
Weak airflow or a complete stop in your Fujitsu Air Conditioner can occur for several reasons. When Heating starts, the fan speed is initially low to allow internal parts to warm up. If the room temperature exceeds the thermostat setting during Heating, the outdoor unit will stop, and the indoor unit will operate at a very low fan speed; adjust the thermostat higher if needed. The unit may also temporarily stop for 7 to 15 minutes during Automatic Defrosting (the OPERATION Indicator Lamp will flash). Additionally, the fan might operate at a very low speed during Dry operation, when the unit is monitoring the room's temperature, during SUPER QUIET operation, or in monitor AUTO operation.
Why does my Fujitsu Air Conditioner emit mist or steam?
The mist or steam emitted from your Fujitsu Air Conditioner has normal causes. During Cooling or Dry operation, a thin mist may appear due to the sudden cooling of room air, causing condensation. During Heating, steam from the outdoor unit may occur during Automatic Defrosting operation, when the outdoor unit's fan may stop.
Why is there noise coming from my Fujitsu Inverter 9316796003-01?
The sound of water flowing may be heard during or immediately after operation. Increased noise may be noticeable for about 2 to 3 minutes after starting. During Heating, a sizzling sound may occur occasionally due to Automatic Defrosting.
Why does my Fujitsu Inverter 9316796003-01 smell?
A smell from your Fujitsu Air Conditioner's indoor unit can result from room odors like furniture or tobacco being drawn into the system.
General| Brand | Fujitsu |
|---|---|
| Model | Inverter 9316796003-01 |
| Category | Air Conditioner |
| Language | English |
Instructions for inserting batteries into the remote control unit.
Procedure to set the current time on the remote control unit.
Steps to start the unit and select the desired operating mode.
Instructions for adjusting the desired room temperature setting.
How to adjust the fan speed (Auto, High, Med, Low, Quiet).
Procedure to turn off the air conditioner unit.
Details on Heating, Cooling, Dry, and Fan modes.
Steps to set a single ON or OFF timer for the air conditioner.
How to set a sequence of ON and OFF timers within a 24-hour period.
Steps to set the sleep timer for automatic operation stop.
Explanation of how the sleep timer adjusts temperature and stops operation.
Step-by-step guide to cleaning the air conditioner's intake grille.
Instructions for cleaning the air filter with vacuum or water.
Instructions for installing air cleaning filters into the unit.
Procedure for replacing used air cleaning filters with new ones.
Addresses common issues like noise, smells, airflow, and damper behavior during normal use.
Steps to diagnose why the air conditioner is not operating at all.
Troubleshooting poor performance and discrepancies with remote control settings.
