Working with the notebook
Inserting battery
1
2
1
► Position the battery at the edge.
► Insert the battery into th e battery compa rtment until it engag es positively (1).
► Slide the release button in the direction of the arrow (2).
► Complete the removal, see chapter "
Finishing component remo val", Page 59.
Optical drive
Opticaldrive
This product contains a light emitting diode, classified in accordance with IEC
8251:1993: LASER CLASS 1, and must therefore not be opened.
Handling d ata carriers
Handling
Observe the following guidelines whe n handling data carriers:
• Avoid touching the surface of a data carrier. On ly handle data carriers by their edges.
• Always store data carriers in their cases. This will protect the da ta carrier against
being covered in dust, scratched or damaged in any other way.
• Protect your data carriers against dust, mechanical vibrations and direct sunlight.
• Avoid storing a data carrier in areas subject to high tempe ratures or humidity.
You may use both 8-cm and 12-cm data carriers in the optical drive.
When using a data carrier of lesser quality, vibrations and reading errors may occur.
Fujitsu Technology Solutions 33
To Next Page
Loading...
