Removing and installing components
during servicing
Attaching the c over
1
2
2
► Place the cover in the correct mounting position (1).
If you r emove more than one component at the same time, keep the screws for the
individual components separately from each other and make sure that you use the
correct screws. If you install the wrong screws, components may be damaged.
► Tighten the screws (2).
► Insert the ba
ttery (see Chapter "Inserting b attery", Page 33).
Finishing component removal
After you have removed or changed the system components as you required, please
prepare your device for operation again as follows:
► Install the battery again (see "
Inserting battery", Page 33).
► Turn the
notebook the right way up again and place it on a flat surface.
► Reconnect the cables that you disconnected before.
Fujitsu Technology Solutions 59
To Next Page
Loading...
