Removing and installing components
during servicing
Installing a hard disk
2
1
► Place the hard disk
into the hard disk compartment (1).
► Use the pulling aid to pull the hard disk in the direction of the arrow (2) until the contacts engage.
Attaching the cover
1
2
2
► Place th e cover in the correct mounting position (1).
If you remove more than one component at the s ame time, keep the screws for the
individual components separately from each other and make sure that you use the
correct screws. If you install the wrong screws, components may be damaged.
► Tighten the screws (2).
► In ser t the battery (s ee Chapter "
Install ing a battery", Page 34).
76 Fujitsu Technology Solutions
To Next Page
Loading...
