Manufacturer’s notes
For Authorized Repair Technicians Only
CAUTION:
For continued protection against r isk of fire, replace only with the
same type and rating fuse.
WARNING:
Danger of explosion if Lit
hium (CMOS) battery is incorrectly replaced. Replace only
with the same or equivalen
t type recommended by the manufacturer.
Dispose of used b atterie
s according to the manufactu rer’s instructions.
FCC regulatory information for notebooks with radio device
Regulatoryinformation
Federal Communications Commission statement
This device complies with Part 15 of FCC Rules. Operation is subject to the following
two conditions: (1) this device m ay not ca use interference, and
(2) this device must accept any interference, including interference that may
cause undesired operation of this device.
FCC Interference Statement
This e quipment has been tested and found to comply with the limits for a Class B digital
device, p ursuant to Part 15 of the FCC Rules. These limits a re designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio freq uency energy. If not installed and used in accordance with
the instructions, it may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving ant enna.
2. Increase the distance be tween the equipment and the receiver.
3. Connect the equipment to an ou tlet on a circuit different from the one the receiver is c onnected to.
4. Consult the dealer or an experienced radio/TV technician for help.
Please note the following regulatory information related to the optional radio device.
FCC Radio Frequency Exposure statement
This radio device has been evaluated under FCC Bulletin O ET 65C an d found compliant with the
requirements as set forth i n C FR 47 Sections 2.1091, 2.1093 , and 15.247 (b) (4) addressing RF
Exposure from radio frequency devices. The rad iated output power of this radio device is far below
the FCC radio frequency exposure limits. Nevertheless, this device shall be used in such a manner
that the potential for human contact during normal operation is minimized. When using this device, a
certain separation distance between antenna an d nearby persons must be maintained to ensu re RF
exposure compliance. In order to comply w ith RF e xposure limits esta blished in the ANSI C95.1
standards, the distance between the antennas and th e user sho uld not be le ss than 20 cm (8 inches).
Regulatory Notes and Statements
Radio device, health and a u th orisation for us e
Fujitsu Technology Solutions 95
To Next Page
Loading...
