To Next PageTo Next PageWhat to do if my Fujitsu Laptop stops working?
If your Fujitsu laptop stops working, it might be in energy-saving mode, so exit that mode. If an application program has caused the malfunction, close the program or restart the laptop. If the battery is dead, charge it, insert a charged battery, or connect the mains adapter.
Why keyboard types only numbers on Fujitsu LifeBook P702?
If certain characters are entered on the keyboard of your Fujitsu laptop and only numerals are written, the virtual numeric keypad of your device is activated. Press the Num key to deactivate it.
What to do if there is stuck key on Fujitsu LifeBook P702?
If a key is stuck on your Fujitsu laptop, make sure that no key is pressed down.
What to do if Fujitsu LIFEBOOK notebook turns off by itself?
If your Fujitsu LIFEBOOK notebook turns off unexpectedly, it could be due to power management settings, a low battery, or a battery failure. Try pressing any keyboard button or moving the mouse, or push the Power/Suspend/Resume button. Check your power management settings in the Control Panel to adjust the timeout values. If you're running on battery, connect a power adapter and press the Power/Suspend/Resume button. Also, verify the battery's condition using the Status Indicator panel; if the battery is shorted, replace or remove it.
What to do if external monitor remains blank with Fujitsu LifeBook P702 Laptop?
If the external monitor is blank, first ensure it is switched on. If power saving mode is active, press any key. Check and adjust the monitor's brightness settings. Verify that the screen output is correctly set, and that both the power and data cables are properly connected to both the monitor and the Fujitsu laptop.
What to do if external monitor is blank or the image is unstable on Fujitsu Laptop?
If the external monitor is blank or the image is unstable, the wrong external monitor might have been selected, or the screen resolution is not set correctly for the application program. Terminate the application program in Windows by pressing Alt + F4. If the problem continues after closing the program, use the key combination for switching the screen output to switch over to the notebook’s LCD screen. Set the screen resolution as described in the documentation for your operating system and select monitor 1 or 2 as described in the documentation for your operating system.
Why does my Fujitsu LifeBook P702 beep every few seconds?
If a beep sounds every few seconds and the battery is almost flat on your Fujitsu laptop, charge the battery.
How to fix radio connection if it does not work on Fujitsu LifeBook P702?
If the radio connection to a network does not work on your Fujitsu laptop, ensure the wireless component is enabled. If it's already enabled but the connection still fails, verify that the radio connection is switched on via the software.
Why Fujitsu LifeBook P702 Laptop will not work on battery?
If your Fujitsu notebook won't work on battery alone, replace the battery with a charged one or install an AC adapter if the installed battery is dead. If no battery is installed, install a charged battery. If the battery is improperly installed, verify that it is properly connected by reinstalling it.
Why Fujitsu LifeBook P702 display goes blank?
If your Fujitsu laptop display goes blank, press a keyboard button or move the mouse. If that fails, push the Power/Suspend/Resume button. Check your power management settings. This usually happens because the notebook has gone into Video timeout, Sleep, or Save-to-Disk mode. Also, power management timeouts may be set for short intervals.
General| Resolution | 1280 x 800 |
|---|---|
| Graphics | Intel HD Graphics 4000 |
| Processor | Intel Core i5 |
| CPU | Intel Core i5-3320M |
| RAM | DDR3 |
| Storage | 320 GB HDD |
| Display | 12.1-inch LED Backlit |
| Operating System | Windows 7 Professional |
| Ports | USB 3.0, VGA, Ethernet, SD card reader |
| Wireless | Wi-Fi 802.11 a/b/g/n, Bluetooth 4.0 |
