73
6 Insert the memory upgrade module at a 45° angle. Press the connector edge of the module firmly down and
into the connector until it lodges under the retaining clip. You’ll hear a click when it is properly in place.
7 Replace the cover and reinstall the screws.
Removing a Memory Upgrade Module
1 Perform steps 1 through 3 of Installing a Memory Upgrade Module.
2 Pull the clips sideways away from each side of the memory upgrade module at the same time.
3 While holding the clips out, remove the module from the slot by lifting it up and pulling it away from your
notebook.
(Figure 24)
4 Store the memory upgrade module in a static guarded sleeve.
5 Replace the cover and reinstall the screws.
Figure 22. Opening Memory Compartment
THE MEMORY UPGRADE MODULE IS NOT SOMETHING YOU ROUTINELY REMOVE FROM YOUR NOTEBOOK.
O
NCE IT IS INSTALLED, YOU CAN LEAVE IT IN PLACE UNLESS YOU WANT TO CHANGE SYSTEM MEMORY
CAPACITY.
To Next Page
Loading...
