90
- Memory Upgrade Module
Checking the Memory Capacity
Once you have changed the system memory capacity by replacing the installed module with a larger one,
be sure to check that your Tablet PC has recognized the change.
• If you are in Control Panel Home view, check the memory capacity by clicking [Start] -> Control
Panel -> System and Maintenance -> System -> View amount of RAM and processor speed. The
amount of memory is displayed next to “Memory - RAM:”
• If you are in Classic view, check the memory capacity by clicking [Start] -> Control Panel ->
System. The amount of memory is displayed next to “Memory - RAM:”
Removing a Memory Upgrade Module
1 Perform steps 1 through 4 of Installing a
Memory Upgrade Module.
2 Pull the clips sideways away from each side of
the memory upgrade module at the same time.
3 While holding the clips out, remove the module
by lifting it up and pulling it away from your
Tablet PC.
4 Store the memory upgrade module in a static
guarded sleeve.
5 Replace the cover and reinstall the screws.
Figure 39. Removing a Memory Module
To Next Page
Loading...
Need help?
General