Fujitsu MHV2100AH - Page 271

Index
C141-E217 IN-3
host pausing ultra DMA data
in burst...............................................5-156
host terminating ultra DMA data
in burst...............................................5-158
out burst.............................................5-162
I
I/O register................................................. 5-7
IDENTIFY DEVICE............................... 5-76
IDENTIFY DEVICE DMA..................... 5-77
IDLE.................................................5-37, 6-9
IDLE IMMEDIATE.........................5-34, 6-9
Information to be read by IDENTIFY
DEVICE command.....................5-78, 5-79
INITIALIZE DEVICE
PARAMETERS................................... 5-30
INITIALIZE DEVICE
PARAMETERS command....................6-8
initiating Ultra DMA data
in burst....................................5-138, 5-151
out burst..................................5-143, 5-159
inner guard band......................................4-15
input voltage..............................................1-6
installation condition.................................3-1
insurance failure threshold ......................5-51
interface..............................................1-3, 5-1
interface signal ..........................................5-2
invalidating caching-target data .............. 6-13
invalidation of cached data...................... 6-19
J
jumper location........................................ 3-11
jumper setting..........................................3-11
jumper setting of master or slave
drive.....................................................3-12
L
large capacity............................................. 1-2
limitation of mounting...............................3-4
load/unload function................................1-11
location of breather.................................... 3-5
location of setting jumper........................ 3-11
log directory data format.........................5-51
logical Interface.........................................5-6
low noise and vibration .............................1-2
low power idle mode.................................6-7
M
master drive-slave drive setting............... 3-12
master/slave...............................................1-3
mean time between failure (MTBF)........ 1-10
mean time to repair (MTTR)...................1-10
media defect.............................................1-11
microprocessor unit (MPU) .....................4-13
miss-hit.....................................................6-15
model and product number ........................1-5
mounting....................................................3-3
mounting frame structure...........................3-4
multiword data transfer..........................5-150
multiword DMA data transfer timing....5-150
N
normal DMA data transfer.....................5-136
O
off-line data collection capability ............5-50
off-line data collection status......... 5-48, 5-49
operation ....................................................6-1
operation of DOWNLOAD
MICROCODE......................................5-32
operation to move head to reference
cylinder.................................................4-18
orientation..................................................3-3
other command ......................................5-135
outer guard band ......................................4-15
outline ........................................................4-2
overview.................................................5-137
P
PAD .........................................................4-17
partial hit..................................................6-18
pausing Ultra DMA data
in burst................................................5-139
out burst..............................................5-144
phases of operation ................................5-138
physical interface.......................................5-2
physical sector servo configuration
on disk surface......................................4-16
PIO data transfer....................................5-149
PIO data transfer timing.........................5-149
PIO data transferring command from
device to host......................................5-129
PIO data transferring command from
host to device......................................5-132
positioning error.......................................1-11
power amplifier........................................4-13
power command.........................................6-9
power on/off sequence...............................1-8
power requirement.....................................1-6
power save .................................................6-7
power save mode ............................... 1-2, 6-7
power supply configuration .......................4-4
power supply connector (CN1)................3-11
power up in standby setting .....................3-14
power-on and reset.................................5-164