Fujitsu MHV2100AH - Page 273

Index
C141-E217 IN-5
STANDBY.......................................5-36, 6-9
STANDBY command ............................... 6-8
STANDBY IMMEDIATE ...............5-33, 6-9
STANDBY IMMEDIATE command........ 6-8
standby mode............................................. 6-8
start mode................................................4-19
status........................................................ 5-54
status flag................................................. 5-48
status register........................................... 5-11
status report in event of error...................6-20
subassembly............................................... 4-2
surface temperature measurement
point....................................................... 3-6
sustained Ultra DMA data
in burst...............................................5-155
out burst.............................................5-160
system configuration ................................. 2-3
T
terminating ultra DMA data
in burst...............................................5-140
out burst.............................................5-145
test span...................................................5-56
the data
in transfer........................................... 5-139
out transfer......................................... 5-144
theory of device operation.........................4-1
timing.....................................................5-149
total number of drive error ......................5-54
track following operation ........................ 4-18
track slip processing................................6-10
U
ultra DMA CRC rule............................. 5-147
ultra DMA data
in command ....................................... 5-138
out command ..................................... 5-143
ultra DMA data burst timing
requirement ........................................5-152
ultra DMA data transfer.........................5-151
ultra DMA feature set ............................5-137
ultra DMA sender and recipient
timing requirement.............................5-154
ultra DMA termination with pull-up
or pull-down.......................................5-148
unload feature ..........................................5-34
UNLOAD IMMEDIATE.........................5-34
unrecoverable read error..........................1-11
using read segment buffer........................6-15
V
VCM current sense resistor (CSR) ..........4-14
viterbi detection circuit............................4-11
W
wide temperature range..............................1-2
WRITE BUFFER.....................................5-75
write cache....................................... 1-3, 6-19
write circuit................................................4-9
WRITE DMA ..........................................5-71
WRITE DMA EXT................................5-117
WRITE DMA FUA EXT.......................5-121
WRITE LOG EXT.................................5-122
WRITE MULTIPLE................................5-65
WRITE MULTIPLE EXT .....................5-120
WRITE MULTIPLE FUA EXT ............5-125
write precompensation...............................4-9
WRITE SECTOR(S)................................5-23
WRITE SECTOR(S) command
protocol ..............................................5-133
WRITE SECTOR(S) EXT.....................5-116
WRITE VERIFY .....................................5-25
write/read recovery ..................................4-17