Page 2 of 14
Disassembly and Repair
We recommend printing out the relevant sections of this chapter prior to installation
as the device for installing/removing hardware components needs to be switched off.
In order to repair the display, please follow the disassembly instructions to remove the defect part, replace it with spare part, then follow the
instructions in reverse order.
If you have received any further documents with your device, you should read these through carefully.
Please note the following instructions before installing/removing system components:
■ The device must be switched off when installing/removing components and it must
not be in power-saving mode.
■ Disconnect the mains plug before opening the device.
■ After unplugging the mains plug, discharge the remaining voltage by pressing the
activation button.
■ Remove all externally connected cables.
■ Take care not to flex foil cablech any cables when installing/removing components.
■ Please ensure that the installed components that might heat up intensely during
operation do not exceed the permitted operating temperature.
!
To Next Page
Loading...
