What to do if my Fujitsu B27-9 TE QHD says 'No Signal'?
If your Fujitsu Monitor displays 'No Signal', ensure the data cable is securely connected to the monitor port on your computer. Also, verify that your computer is powered on.
How to fix a Fujitsu B27-9 TE QHD with no screen display but power indicator is lit?
If your Fujitsu Monitor screen is not displaying anything but the power indicator is lit, make sure that the computer is switched on. Check that the monitor data cable is correctly connected to the computer. Try pressing any key on the keyboard in case the computer is in power saving mode. You may also need to adjust the brightness and contrast settings.
Why is the picture shaking on my Fujitsu B27-9 TE QHD Monitor?
If your Fujitsu Monitor's picture is shaking, check that the monitor's data cable is correctly screwed into the monitor port on the computer. If the issue persists, run the Auto adjust function.
How to fix 'Frequency out of range' on Fujitsu B27-9 TE QHD Monitor?
If you see the message 'Frequency out of range' on your Fujitsu Monitor, it means the input signal doesn't match the monitor's technical specifications. Reboot the system after connecting to the monitor. Try adjusting the video frequency range or setting a different screen resolution using your computer's software.
What to do if the picture position is not correct on my Fujitsu Monitor?
If the picture position on your Fujitsu Monitor isn't correct, it might be recognizing an undefined mode. Try running the Auto adjust function.
How to correct a wrongly adjusted picture on Fujitsu B27-9 TE QHD?
If your Fujitsu Monitor's picture is wrongly adjusted, use the Factory Recall function. An Auto Processing message will appear.
What causes vertical lines on my Fujitsu B27-9 TE QHD and how to fix it?
If you are experiencing picture disturbances with vertical lines on your Fujitsu Monitor, run the Auto adjust function.
How to eliminate horizontal lines or picture noise on a Fujitsu B27-9 TE QHD Monitor?
If you notice horizontal lines or picture noise on your Fujitsu Monitor, try running the Auto adjust function.
To Next Page
General