Fujitsu Plasmavision P42HTA51E Series User Manual

E-15
EnglishDeutschEspañolFrançaisItalianoPortuguês
日 本 語
Póññêèé
中文
RGB INPUT MODE
1
Press  to select the input mode.
The input terminal of RGB mode is as follows.
• RGB1: mD-sub
* For selection of the input terminal, see
“SETTING THE INPUT TERMINALS” on
P. E-25.
CONVENIENT FUNCTIONS
DISPLAY
Displaying on-screen information.
Press
3 .
The channel or mode is indicated on the screen for 5 seconds.
PICTURE MODE
Press 4 .
This button can be used to switch the picture mode.
In the picture mode, you can switch between the set status and the fine mode.
* For the picture mode settings, see “Picture Mode (P. E-20)”.
PICTURE MEMORY
Press 5 .
This button can be used to recall the settings of the picture memories 1 – 8. Each time this button is
pressed, the setting changes as follows.
* For the picture memory settings, see “Picture Memory (P. E-21)”.
DUAL CHANNEL
Press G .
This function enables selection of the audio mode when there is a dual-channel broadcast. Each time this
button is pressed, the mode is switched as shown in the figure below.
Depending on the broadcast, this function may not be available.
OFF-TIMER
Press 7 .
This can be used to set the time before the power is turned off (Stand-by state). Each time this button is
pressed, the setting changes as follows.
Note
• Functions may not be available with some models and some device options.
RGB1 mode
Memory1 Memory2 Memory3 Memory4 Memory5 Memory6 Memory7 Memory8
Dual-I Dual-II Stereo Mono
Off 30 min. 60 min. 90 min. 120 min.
01_E_7473.book 15 ページ ２００６年９月６日 水曜日 午後２時３６分

Fujitsu Plasmavision P42HTA51E Series Specifications

General

Brand	Fujitsu
Model	Plasmavision P42HTA51E Series
Category	Monitor
Language	English