48 Operating Manual TX2550 M4
5.1 Unpacking the server
V CAUTION!
Follow the safety instructions in chapter "Important information" on
page 33.
The server must always be lifted or carried by at least two people.
For Japan:
Please refer to " 安全上のご注意 ".
Do not unpack the server until it is at its installation location.
Ê Transport the server to the place where you want to set it up.
Ê Unpack all individual parts.
Keep the original packaging in case you want to transport the server again
(does not apply to Japan).
Ê Check the delivery for any damage during transport.
Ê Check whether the items delivered match the details on the delivery note.
The product name and serial number of the product can be found on the ID card,
see section "ID card" on page 72.
Ê Notify your supplier immediately should you discover that the items
delivered do not correspond to the delivery note.
Ê Remove all scratching protection foils from the front panel, HDD frames, and
PRIMERGY logo, VGA dummy and ODD dummy in case they are still
sticked to the server system.
To Next Page
Loading...
Need help?
General