Automatic Power OFF
When the ScanSnap connected with a USB cable is turned on and left unused for the specified time
(default is "4 hours"), it will turn itself off automatically.
When the ScanSnap powered by a battery is turned on and left unused for the specified time (default
is "5 minutes"), it will turn itself off automatically.
To turn the ScanSnap back on, perform one of the following operations:
l Press the [Scan/Stop] button on the ScanSnap
l Close the feed guide and open it again
HINT
l To continue using the ScanSnap, reset the time until auto power-off by performing one of the
following:
- Load a document in the ScanSnap
- Press the [Scan/Stop] button on the ScanSnap
- Close the feed guide and open it again
l You can change the time of the ScanSnap to turn off automatically or change the setting so that it
will not turn off automatically. Set according to the following procedures:
1. Right-click the ScanSnap Manager icon
in the notification area and select [Preferences]
from the "Right-Click Menu" (page 45).
a The [ScanSnap Manager - Preferences] window appears.
2. In the [Power] list, change the settings for [Power setting] based on how it is connected.
l A notification appears in the following cases:
- When a USB cable is used for connection, the ScanSnap will turn off automatically five minutes
later.
- When the ScanSnap is powered by the battery, the ScanSnap has turned off automatically.
Turning the ScanSnap On or Off
53
To Next Page
Loading...
Need help?
General
Weight and Dimensions
