ETERNUS LT40 S2 tape library Periphery
36 U41861-J-Z126-1-76
4.2.1 Front panel
The power button, operator control panel (OCP), magazines and LEDs are located on the
front of the tape library.
The operator panel consists of an LCD screen, 4 push button switches and a power on/off
button.
Figure 13: ETERNUS LT40 S2 front panel
1 Left-hand or right -hand magazine. Left-hand magazine with mailslots.
2Air vents
3 Power button. Pressing the button will power up or power down the library, see page 39 and
page 42.
4 READY LED (green).
Illuminated when power is on.
Blinking when there is tape or robotics activity.
5 CLEAN LED (yellow).
Illuminated when the tape drive has determined that a cleaning cartridge should be used.
6 the OCP's LCD screen, consisting of 128 x 64 characters.
Displays actions and status information, menu items or error messages.
7 ATTENTION LED (yellow).
Illuminated if the library has detected a condition that requires attention by Customer Support.
Please notify customer support.
8 ERROR LED (yellow).
Illuminated if an unrecoverable tape drive or library error occurs. A corresponding error
message displays on the LCD screen.
Please notify customer support.
9 Control key buttons
▲ (UP) and ▼ (DOWN).
These buttons are used to navigate through the OCP menu items.
To Next Page
Loading...
