Periphery ETERNUS LT40 S2 tape library
U41861-J-Z126-1-76 57
Dokuschablonen 19x24 Version 7.4us für FrameMaker V7.x vom 09.02.2010 © cognitas GmbH 2001-2010
Dokuschablonen 19x24 Version 7.4us für FrameMaker V7.x vom 09.02.2010 © cognitas GmbH 2001-2010
29. June 2015 Stand 16:47.07 Pfad: P:\FTS-BS\Server\SE-Server\SE-Doku\1303909_BA_Additional\prod_e\ba_addon.k05
2. The finger holes on the back side of the magazines (see figure) allow the user to pull
the cartridges out of the slot. Remove and insert the cartridge mechanically. Repeat the
process several times.
Figure 17: Removing stuck tapes from slot
3. During this process the burr will be removing.
4. Insert cartridge in the magazine
5. Put the magazine back to the tape library.
Magazine does not unlock
If you are not able to remove the magazines using the OCP or the RMU, an emergency
release mechanism is available.
i Detach the tape library while BS2000 is operating (/DETACH-DEVICE) before you
start your manual work on the tape library.
v CAUTION!
Use only in case of emergency!
1. Unplug the power cord from the library.
2. Find the access holes for the right and left magazines.
To Next Page
Loading...
