Fujitsu SP-1120 User Manual

Chapter 2 How to Load Documents
31
Appendix
Glossary
Contents
TOP
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Index
Introduction
Precautions
The following types of documents may not be scanned successfully:
 Tracing paper
 Documents that are not square or rectangular
 Extremely thin paper
The following types of documents must not be scanned:
 Paper-clipped or stapled documents
 Documents on which the ink is still wet
 Documents smaller than A8 size (portrait)
 Documents other than paper/plastic card such as fabric, metal foil
and OHP film
 Important documents that must not be damaged or smeared
 Documents of non-uniform thickness (e.g. envelopes, documents with
attachments)
 Wrinkled or curled documents
 Folded or torn documents
 Coated paper
 Carbon paper
 Carbonless paper
 Photosensitive paper
 Perforated documents
 Photographs (photographic paper)
ATTENTION
 Since carbonless papers contain chemical substances that may
harm the rollers (such as the pick roller), the scanner may fail.
 When scanning wood-containing papers, the life of the brake roller
and pick roller may end sooner compared to scanning wood-free
papers.
 The brake roller and pick roller may be damaged when a photo/sticky
note on a document gets into contact with these parts during
scanning.
 The surface of a document may be damaged when scanning gloss
papers such as photographs.
ATTENTION
 When you scan plastic cards, take note of the following.
- Plastic cards should be loaded one card at a time in the ADF paper
chute (feeder).
- It is recommended to place the card face-down in the ADF paper
chute (feeder).
- Cards should be within the following specifications:
ISO7810 ID-1 type compliant
Size : 85.6 × 53.98 mm
Thickness : 0.76 mm or less (Embossed cards allowed (ISO7810
ID-1 type compliant))
Material : PVC (polyvinyl chloride) or PVCA (polyvinyl chloride
acetate)
Make sure to check if the card can be scanned first.
- Rigid cards may not be fed properly.
- If the surface of the card is dirty with grease marks (e.g.
fingerprints) and such, perform scanning after wiping the dirt off.
- Scanning thick documents such as plastic cards will be falsely
detected as multifeed.
In this case, disable multifeed detection.
Back

Fujitsu SP-1120 Specifications

General

Brand	Fujitsu
Model	SP-1120
Category	Printer
Language	English