Chapter 8 Operational Settings
95
Appendix
Glossary
Contents
TOP
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Index
Introduction
Item Description Parameter/Value Factory Default
Count
(page 96)
Check the counters to determine when to replace
the consumables.
Also use it to reset the counters after replacing
the consumables.
Total Count (ADF)/Roller Set 0
Power saving
(page 98)
Specify the waiting time before entering power
saving mode.
Range: 5 to 235 min. (in increments of 5) 15 min.
Power off after a certain period of time: Select to
set the scanner to turn the power off
automatically if the scanner is left on for a certain
period of time without being used.
Specify the timeout period for the scanner to be
automatically turned off.
[Power off after a certain period of time] check box Selected
1 Hour/2 Hours/4 Hours/8 Hours
(When the [Power off after a certain period of time] check box
is selected)
4 Hours
To Next Page
Loading...
Need help?
General