Chapter 8 Operational Settings
98
Appendix
Glossary
Contents
TOP
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Index
Introduction
Waiting Time to Enter Power Saving Mode (Power
saving)
The waiting time for the scanner to enter power saving mode
can be specified.
1 Start the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 86).
2 From the listing on the left, select [Device Setting].
3 Use the slider to specify the waiting time before entering
power saving mode.
The value can range from 5 to 235 minutes (in increments of 5).
8.5 Settings Related to Waiting Time
HINT
Selecting the [Power off after a certain period of time] check box
turns the power off automatically if the scanner is left on for a
certain period of time without being used.
You can select the timeout period for the scanner to be
automatically turned off from 1 Hour/2 Hours/4 Hours/8 Hours.
To Next Page
Loading...
Need help?
General