Chapter 8 Operational Settings
97
Appendix
Glossary
Contents
TOP
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Index
Introduction
■Resetting the sheet counters
When you have replaced or cleaned a consumable part, reset the
corresponding counter by using the following procedure.
1 Click the [Clear] button for the consumable that you
replaced.
The counter is reset to 0.
2 Click the [OK] button in the Software Operation Panel.
A confirmation message appears.
3 Click the [OK] button.
The settings are saved.
■Message for replacing the consumables
The following message may appear while using the scanner.
Check the message and replace the consumable accordingly.
If you click the [Ignore] button, the message disappears and
the scan can be continued. However, it is recommended that
you replace the consumable as soon as possible.
To stop the scan and replace the consumable right away, click
the [Cancel] button.
For details about replacing consumables, refer to "6.2
Replacing the Roller Set" (page 59).
Message for replacing consumables
To Next Page
Loading...
Need help?
General