Fujitsu SP1120 - Cleaning the Inside; Cleaning the ADF (with Cleaning Paper)

SP1120\1125\1130 Consumable Replacement and Cleaning
Instructions
12
CG00002-291501
Cleaning the Inside
Cleaning the ADF (with Cleaning Paper)
 Turn on the scanner.
 Spray the Cleaning Paper with Cleaner F1
 Pull out the chute extensions according to the length of the Cleaning Paper. Lift the
stacker and stacker extension according to the length of the Cleaning Paper.
 Load the Cleaning Paper in the ADF paper chute (feeder).Adjust the side guides to the
width of the Cleaning Paper. Do not leave space between the side guides and the
Cleaning Paper. Otherwise, the Cleaning Paper may be fed skewed
The ADF can be cleaned with a sheet of Cleaning Paper moistened with Cleaner F1.
As the scanner continues to feed the documents, paper dust will accumulate inside the ADF and it
may cause scanning errors.
Cleaning should be performed approximately every 3,000 sheets scanned. Note that the cleaning
frequency varies depending on the types of documents you scan. For instance, it may be necessary
to clean the scanner more frequently when you scan documents on which the toner is not
sufficiently fused.
ATTENTION
• Do not use water or mild detergent to clean the ADF.
• It may take a long time to dry if an excessive amount of Cleaner
F1 is used. Use it in small quantity.
 Start an application for scanning and perform a scan.