SP1120\1125\1130 Consumable Replacement and Cleaning
Instructions
3
CG00002-291501
Replacing the Roller Set
The roller set consists of a brake roller and a pick roller. Replace each roller in the following
procedure.
5. Attach a new brake roller on the shaft
1 Remove all documents from the ADF paper chute (feeder).
Open the ADF.
Remove the brake roller.
a. Press the cover bushing of the brake roller to open the cover in the
direction of the arrow.
Be careful not to have your fingers caught
when the ADF closes.
b. Pull out the left side of the brake roller shaft, and then pull out the right side of the shaft from the hole.
4. Remove the brake roller from its shaft
To Next Page
Loading...
