SP1120\1125\1130 Consumable Replacement and Cleaning
Instructions
6
CG00002-291501
8. Attach a new pick roller from the bottom.
a. Check the direction of the notch on the pick roller and of the small roller, and insert it in the hole.
b. Close the sheet guide.
ATTENTION
Check that the pick roller is installed properly. Otherwise, it may cause feeding errors such as paper jams.
9. Close the ADF.
Be careful not to have your fingers caught when the ADF closes.
10. Reset the roller set counter.
Start the Software Operation Panel and reset the counter.
To Next Page
Loading...
