12-4 SPARC Enterprise M8000/M9000 Servers Service Manual • June 2010
6. Remove the HDD unit to be replaced.
a. Press the square push button on the HDD unit to be replaced.
The eject/lock lever protrudes at an angle of about 45 degrees.
b. Pull the eject/lock lever to an angle of about 90 degrees to release the lock.
c. While grasping the eject/lock lever, pull out the HDD unit slowly from the
slot.
FIGURE 12-2 Removing the HDD
7. Place the removed HDD on an antistatic mat.
To Next Page
Loading...
