56
Stylistic ST4110 Fujitsu Tablet PC User’s Guide - Section One
Problem
Cannot connect to
the network
Possible Cause
There are several
possible causes, as
listed to the right.
Refer to the specific
section of this
manual or your
user’s manual.
Possible Solution
5. To check that your system is communicating with
other systems, go to the DOS prompt and type:
\>ping XXX.XXX.XXX.XXX. (With the destination IP
address in place of XXX.XXX.XXX.XXX).
Example: if the destination IP address is 10.0.1.3:
C:\>ping 10.0.1.3
A message similar to the following appears if the
connection is successful.
Pinging 10.0.1.3 with 32 bytes of data:
Reply from 10.0.1.3: bytes=32 time=1ms TTL=32
Reply from 10.0.1.3: bytes=32 time<10ms TTL=32
Reply from 10.0.1.3: bytes=32 time=4ms TTL=32
Reply from 10.0.1.3: bytes=32 time<10ms TTL=32
If the connection fails, [Request timed out],
[Destination host unreachable], or a similar message
appears. In this case, refer to the “Other computers
are not displayed” portion of this chapter.
The following causes are possible. Check each one
of them.
• The network name or encryption key is not right.
• The driver has not correctly started.
• The destination computer is not turned on.
• You do not have the access privilege to the
destination computer.
• The card has failed.
• Hardware conflict.
Alb6_UG (50-60) 10/24/02, 11:53 AM56
To Next Page
Loading...
