En-10
Copyright© 2013-2016 Fujitsu General Limited. All rights reserved.
6. CONNECTION
Connect the PC to the outdoor unit’s PCB via the
Communication control box (MA306 manufactured
by Micro application).
There are three types of connectors on the control
PCB.
Choose the cable required based on the three
types listed below:
TYPE1 : PA connector -6 pin
TYPE2 : PA connector -10 pin
TYPE3 : PA connector -12 pin
WARNING
You must turn off the power and
wait 5 min. before you connect or
remove the Communication con-
trol box to the Control PCB.
Communication
control box
Control PCB
of outdoor unit
Cable for control PCB(TYPE1/2/3)
USB cable
* When there is no connector on the control PCB.
The connector for communication may not be soldered onto the control PCB.
In this case please use the following connector:
Connector
Manufacturer Model number
JST B10B-PASK-1
Caution
You must turn off the power supply, before mounting the connector on the control PCB.
(There is a possibility of electric shock.)
Please make sure the boss lines up with the locating point on the PCB.
Please be cautious when connecting the connector as it can cause damage if not tted
correctly.
boss
Location point
To Next Page
Loading...
