Fujitsu UTY-RVRY UTY-RVRG UTY-RVRX - Backlight; Operation Lamp

5-3-7 Backlight
5- 3-7-1
5- 3-7-2
5-3-7-3
5- 3-7- 4
(a) (b)
(a) Backward button
Tap to return to the previous screen.
(b) Home button
Tap to move to the temperature setting screen (home
screen).
5-3-7-1 Brightness Sensor Control
Automatically adjusts the brightness of the screen according
to the brightness of the room.
(a)
(a) Toggle button
Taptotoggleenable/disable.
Enable: The backlight is controlled according to the am-
bient brightness detected by the ambient light
sensor on this controller.
Disable: Conforms to the “5-3-7-2 Brightness” (refer to
5-3-7-2) setting.
5-3-7-2 Brightness
(1) Tap the brightness to
use.
(2) Tap [
] to return
to the previous
screen.
5-3-7-3 Time after lighting
Selectwhethertoo󰀨ordimthebacklightafteroperatingthis
remote controller.
O󰀨: Afterthetimesetin“AutomaticO󰀨Time”(refer
to 5-3-7-4) has passed, the backlight will turn
o󰀨.
Dimming: After the time set in “AutomaticO󰀨Time” (refer
to 5-3-7-4) has passed, the brightness of the
backlight will be reduced and one of the follow-
ingwillbedisplayed:
• Display a registered image. (Only if an image
was registered during installation.) Set “Logo
Display” (refer to 5-3-5) to “Enable”.
• Display the standby mode screen. (refer to
1-4-2)
NOTE
To prevent screen burn-in, it turns off once every 30 min-
utes.
(1) Tap the item to use.
(2) Tap [
] to return
to the previous
screen.
5-3-7-4 AutomaticO󰀨Time
Setsthetimeuntilthebacklightturnso󰀨ordims.
(1) Tap the time to use.
(2) Tap [
] to return
to the previous
screen.
5-3-8 Operation Lamp
Sets the behavior of the operation lamp. For the operation
lamp, refer to “1-3 Name of parts”.
(a)
(a) Toggle button
TaptotoggleON/OFF.
ON: The operation lamp lights up while the in-
door unit is operating and goes out while it is
stopped.
OFF: The operation lamp is always goes out.
En-25