Fujitsu Waterstage DHW Series - Appliance End-of-Life; System Configuration Overview

- 5 -
►
Appliance end-of-life
The appliances must be dismantled and recycled by a
specialised service. The appliances must not, under any
circumstances, be thrown out with household waste,
bulky waste or at a tip.
At the end of its service life, please contact your installer
or local representative to proceed with its dismantling
and recycling.
g. 1 - Overview of complete installation conguration
►
Overview of the installation
Your heat pump has been congured by your installation
engineer. It is made up of the following main parts:
- The outdoor unit, as its name suggests, is placed
outside your dwelling, and extracts energy from the
outside air.
- The hydraulic unit is located in your boiler room, cellar,
garage or even in your kitchen, and transfers energy to
the heating and domestic hot water circuits*.
- The outside sensor monitors the outside temperature.
Optional:
- Room sensor(s).
Heat pumps are systems which can be connected to
any type of low temperature distribution system and
the heat captured by the heat pump can be used in
di󰀨erent ways:
- Underoor heating system.
- Radiators.
- Domestic Hot Water (DHW)*.
Menu
* depending on conguration / option
Room thermostat
(wired or radio)
Remote control
(wired or radio)
Outside
sensor
Heating circuit
underoor heating
Radiators heating
circuit
Boiler
Options depending
on hydraulic
congurations
2
circuit kit
Boiler
connection kit
Hydraulic unit
Outdoor unit
Control options
and/or
or
Waterstage / OPERATING INSTRUCTIONS / 2010 - EN