Fujitsu Waterstage Split Comfort 5 Series - Description of the Equipment; Packing; Unpacking and Supplies; Defi Nitions

- 6 -
 Description of the equipment
►
Packing
• 1 package: Outdoor unit.
• 1 package: Hydraulic unit and outside temperature
sensor.
►
Defi nitions
- Split: The heat pump consists of two elements
(an outdoor unit to be installed outdoors and a hydraulic
unit to be installed inside the dwelling).
- Air/water: The surrounding air is the energy source.
This energy is transmitted to the heating circuit water
by the heat pump.
- Inverter: The fan and compressor speeds are
modulated according to the heating requirements.
This technology enables you to save on energy and
operate on a single-phase power supply, whatever
the heat pump’s output, by avoiding pulling signifi cant
amounts of current at start-up.
- COP (Coeffi cient of Performance): This is the
relationship between the energy transmitted to the
heating circuit and consumed electrical energy.
►
Optional equipment
• 2nd circuit kit (code UTW-KZDXE)
for connecting 2 heating circuits.
• Regulation extension kit (code UTW-KREXD)
to manage a 2nd heating circuit, telephone modem
etc...
• 6 kW backup relay kit (code UTW-KBHXL)
for switching to HP electrical backup of 3 to 6 kW.
• Boiler connection kit (code UTW-KBDXD)
for connecting a boiler to the heat pump.
• Room thermostat (code UTW-C55XA),
Wireless room thermostat (code UTW-C58XD)
for correcting the ambient temperature.
• Remote control (code UTW-C74TXF or UTW-C74HXF),
Wireless remote control (code UTW-C78XD)
for correcting the ambient temperature and
programming the heat pump.
• Cooling kit (code UTW-KCLXL).
• DHW expansion kit (code UTW-KDEXL).
►
Operating Range
This heat pump provides:
- Heating in winter,
- The management of electrical backups, for extra
heating on the coldest days,
or
- Installation with boiler connection* for extra heating on
the coldest days,
- Management of two heating circuits*,
- Production of domestic hot water.
- Cooling in summer* (for underfl oor heating-cooling
system or fan-convectors).
* : According options / require the use of additional kits
(see chapter “Required accessory” or “Optional equipment”).
Accessories
Outdoor temperature sensor
Adapter 1/2”-5/8” and/or 1/4”-3/8”
(1)
Nut 1/2” and/or 1/4”
(1)
Elbow
(2)
Plug
(2)
X 3
Cable grommet
(2)
X2
1
Only models 5 / 6 and 8
2
Only models 10
Waterstage Split Comfort DHW Serie / INSTALLATION / 2125 - EN
Packing contents list
Heat Pump Outdoor unit Hydraulic unit
Model Reference Reference
Waterstage Split Comfort Series 5 WOYA060KLT WGYA050ML3
Waterstage Split Comfort Series 6 WOYA060KLT
WGYA080ML3
Waterstage Split Comfort Series 8 WOYA080KLT
Waterstage Split Comfort Series 10 WOYA100KLT WGYA100ML3