What does 'DS-7000 Hardware Error' mean on Fukuda Denshi Medical Equipment and how to fix it?
Proper voltage is not being supplied to the internal circuit. Check the item judged as NG on the maintenance menu.
What to do if the 'Check Electrodes' message is displayed on Fukuda Denshi DynaScope 7000?
If you see a 'Check Electrodes' message, it means an electrode is detached or not making good electrical contact with the skin. Ensure all electrodes are properly attached.
Why is the cuff not inflating on my Fukuda Denshi DynaScope 7000, even though the pump is running?
The air hose may not be firmly connected, causing air leakage. Check if the air hose is properly connected. Also, the cuff size may not match the selected patient type; verify that the cuff size is appropriate for the patient.
How to fix a blurry display on Fukuda Denshi DynaScope 7000 Medical Equipment?
Adjust the display brightness to an appropriate level. Also, check if the monitor is set to night mode and cancel it if necessary.
What to do if Fukuda Denshi DynaScope 7000 keeps restarting?
The memory data may have been corrupted due to noise. Set the rotary switch inside the maintenance cover to the initial setting (F), then turn the power ON again. After the program starts, return the rotary switch to '0'. If the issue continues, consider a faulty CPU board.
What does the “CVA Detected” message mean on Fukuda Denshi Medical Equipment?
Heartbeat is interfering and superimposed with the respiration waveform. Place the electrode where the heartbeat will be less likely to interfere.
Why can't I read or write to the CF card in my Fukuda Denshi DynaScope 7000?
The CF card is not formatted. Format the card on the DS-7000. If the problem persists, a faulty CPU board or CF card may be the cause.
Why is the BP waveform not properly received above 100mmHg on my Fukuda Denshi DynaScope 7000?
The BP waveform and scale do not match. When the BP waveform is above 100mmHg, set the BP scale above 100mmHg.
Why does my Fukuda Denshi DynaScope 7000 repeat measurements or display '? ? ?'?
The measurement accuracy is unreliable due to body motion artifact. Ensure the patient stays as still as possible during the measurement.
What does 'TEMP not connected' mean on Fukuda Denshi DynaScope 7000 and how to fix it?
This message appears when the temperature sensor is disconnected during temperature monitoring. To resolve this, plug in the temperature sensor. This will clear the message and silence the alarm.
General| Category | Medical Equipment |
|---|---|
| Type | Patient Monitor |
| Display | Color LCD |
| Paper Speed | 25/50 mm/s |
| Input Impedance | ≥10 MΩ |
| Power Supply | AC power, Rechargeable battery |
| ECG | Yes |
| Respiration | Yes |
| SpO2 | Yes |
| NIBP | Yes |
| Temperature | Yes |
| Storage | Internal memory |
| Operating Humidity | 30% to 85% (non-condensing) |
| Weight | Approx. 5 kg (including battery) |
To Next Page
