Fulling DZB200M - Terminal Control Modes (Two-Wire;Three-Wire)

K1
K2
Sx(FWD)
Sx(REV)
DCM
DZB
Series
OFF
OFF
Op era tion
Command
K1 K2
ON
OFF
OFF ON
ON ON
STOP
FWD
REV
STOP
This par amet er defines four different control modes w hich controls the inverteroperat ion through
ex ter n al te rm inals.
0: Two-w ire typ e con tr ol, in t e grate Enable wit h direc tio n . T his mode is the m o st o fte n u sed tw o- w ire
controlmode. The motor forward and reverse operations are determi ned by the defined FWD and REV
terminalcommand.
Fig. 6-8 Two-wire operationmode 1
1: Two-w ire c ontrol , s epar ate Enable from dire ction. When t his mode i s us ed, the defined F WD is ena ble
t erminal.The dir ection i s determined by the defined REV state.
Fig.6-9 Two-wire operation m ode 2
K1
K2
Sx(FW D)
Sx( R E V)
DCM
DZB
Series
OFF
OFF
K1 K2
ON
OFF
OFF ON
ON ON
Op era tion
Command
FWD
REV
STOP
STOP
Chapter 6 Parameter Descr iption
DZB S eri es
F2.07
Ter minal control
mode
0two-wirecontrol1
：
1two-wirecontrol2 ：
2 three-w ire c ontro l 1 ：
3 three-w ire c ontro l 2 ：
0
Fu nction
Code
Name
Set t ing Ra ng e
Default
Value
-47-
3: Three-wi recontrol,se pa rate Enable fromdi rection.At this mod e EN is theEn able terminal, SW1 or
SW2define operati ng commandand control direct ion at thesametime.S top command is defined by SW2.
SW1 F WD operatingbutton SW 2 STOP but ton SW3 REV oper ating button
：：：
EN i sdefiningt hecorresponding t erminal f unc tion as F unction 3 Three-wireoperation control . “”
N ote: For two-wire operation mode,whenFWD/REVterminal is enabled and th e stopc ommand
produced by o ther sources stopst he equipment, the inverterdoes not start to operate af terthe s top
command d isappears eve n if the control t erminalFWD /R EV is still valid. If t he i nv erter needs to
operate,it is required totrigger FWD/REVagain.
F ig. 6-11 Three -wireoperation mode 2
Sx(FWD)
Sx(EN)
Sx(REV)
DCM
SW1
SW2
SW3
DZ B
Series
Chapter 6 Parameter D escripti on
DZB Series
2: Three-wire control 1, integrate Enable withdirection. At this mode,ENis the Enable terminalwiththe
direction controlled by the defined F WD.REV defi ne the dir ection.
K FWD/REV s wi tch SW1 R UN butt on SW2 S TOP but ton
EN i sdefiningt he correspondi ngterminal function as Funct ion 3 Three-wire operation control .
：：：
“”
Fig. 6-10 Three-wir e operation mode 1
K
OFF
ON
Operation
Comm and
FWD
REV
Sx(FWD)
Sx(EN)
Sx(REV)
DCM
SW1
SW2
K
DZB
Series
-48-
BLUE ELEPHANT BLUE ELEPHANT BLUE ELEPHANT BLUE ELEPHANT
BLUE ELEPHANT BLUE ELEPHANT BLUE ELEPHANT BLUE ELEPHANT
BLUE ELEPHANT BLUE ELEPHANT BLUE ELEPHANT BLUE ELEPHANT
BLUE ELEPHANT BLUE ELEPHANT BLUE ELEPHANT BLUE ELEPHANT
BLUE ELEPHANT BLUE ELEPHANT BLUE ELEPHANT BLUE ELEPHANT
BLUE ELEPHANT BLUE ELEPHANT BLUE ELEPHANT BLUE ELEPHANT