FT-C Vertical Electric Thermal Fluid Heater Manual 12 2013 ISSUE 1
Initial Start-Up 3.6
Start-Up Service 3.6.1
Cold Circulation 3.6.2
Filtering the System 3.6.3
Sytem Boilout 3.6.4
Procedure For First Shutdown 3.6.5
Sequence of Operation 3.6.6
Duel Fuel Burner-Changing Fuel 3.6.7
Gas Fired Modulating Burner 3.6.8
Setting Main Burner Ignition 3.6.9
Setting Main Run Modulation 3.6.10
Setting Low Fire 3.6.11
Setting the Complete Range 3.6.12
Changing Set Point on the AZL 3.6.13
For Manual Operation 3.6.14
Required Pressure Drop Across the Heater 3.7
Required Flow Through the Heater 3.8
Operating Controls 3.9
Liquid Level Switch - When Combination Tank is Supplied 3.9.1
Required Maintenance at First Shutdown 4.1
Maintenance Procedures 4.2
Lubrication 4.2.1
Soot Cleaning 4.2.2
Schedule of Operator Tests and Checks 4.3
Daily 4.3.1
Weekly 4.3.2
Monthly 4.3.3
Six Monthly 4.3.4
Annually 4.3.5
Safety Check Procedures 4.4
Temperature Limits 4.4.1
Air Switch 4.4.2
Air Filter Box Switch 4.4.2.1
Liquid Level Switch 4.4.3
Differential Pressure Switch 4.4.4
Low Inlet Pressure Switch 4.4.5
High Outlet Pressure Switch 4.4.6
High/Low Gas Pressure Switch 4.4.7
Troubleshooting 4.5
Troubleshooting: Flow Circuit/Circulating Pump(s) 4.5.1
To Next Page
Loading...
