FULTON Vantage VTG 4000 - User Manual

149 pages

Save Page as PDF

To Next Page

To Next Page

Loading...

INSTALLATION AND

OPERATION MANUAL

Vantage (VTG)

Condensing Hydronic Boilers

Standard, Dual Fuel, and Low Emissions Models

2,000,000 - 6,000,000 BTU/HR

504k - 1.5 MM kCal/HR

Serial/ National

Board Number

Model

Fulton Order

Owner

Site Name

Date

VTG-IOM-2016-1214

Table of Contents

Questions and Answers

E
eric99Aug 9, 2025
What to do if the pilot fails on my FULTON Boiler?
- C
  Chad AlexanderAug 9, 2025
  If the pilot fails on your FULTON Boiler, several factors could be at play. Start by ensuring the manual shut-off valves are open, allowing gas to flow to the pilot tube. Then, adjust the incoming gas pressure and pilot gas pressure regulator to match the start-up report. If these steps don't resolve the issue, there may be air in the pilot gas line. In that case, allow the boiler to attempt lighting up to three times. If it still fails, it is recommended to call Fulton.
D
David CervantesAug 29, 2025
How to fix a FULTON Boiler when the control doesn't illuminate?
- M
  Margaret BowersAug 29, 2025
  If the control panel on your FULTON Boiler isn't lighting up, it's likely a power supply issue. Check the fuse or circuit breaker and reset or replace it as needed.
J
Jessica JohnsNov 18, 2025
Why won't the fan start on my FULTON Boiler?
- D
  Dominique WeaverNov 19, 2025
  If the fan on your FULTON Boiler isn't starting, there are several potential causes: * A high temperature, low gas, or high gas trip may have occurred. In this case, try resetting the switch. If that doesn't work, the switch may need replacement. * The UT32A may be incorrectly set, preventing heat. Adjust the UT32A accordingly. * The flame detector may be detecting an extraneous light source. Identify and remove the light source. If the problem persists, replace the flame detector. * The air switch may be activated when the fan is off. Try resetting the switch, and if that doesn't work, replace it. * The blower contactor might be engaged when the fan is off. If so, replace the motor contactor. * A defective gas valve proof of closure can also prevent the fan from starting. Rep...

Summary

Introduction

Warnings & Cautions

Essential safety information to prevent injury or death and equipment damage.

Operation

Perform Pre-Start-Up Inspection

Checklist of essential inspections before initial boiler start-up.

Fill and Purge the System

Step-by-step guide for filling and purging the hydronic heating system.

Commission The Boiler

Procedures for commissioning the boiler after installation, ensuring proper operation.

Steps to Enter Parameters

Instructions on how to access and navigate the boiler's parameter settings.

Adjusting Fuel;Air Curve (Natural Gas or Propane or Modulating #2 Fuel Oil)

Maintenance

Daily Maintenance and Inspection Schedule

Annual Maintenance and Inspection Schedule

Inspecting;Cleaning the Flue Passages

Troubleshooting

Guide to diagnosing and resolving common boiler operational issues.

FULTON Vantage VTG 4000 Specifications

General

Brand	FULTON
Model	Vantage VTG 4000
Category	Boiler
Language	English

Related product manuals

FULTON Vantage VTG 4000DF

FULTON Vantage VTG 2000

FULTON Vantage VTG 3000

FULTON Vantage VTG 5000

FULTON Vantage VTG 6000

Preview: FULTON Vantage VTG Series

FULTON Vantage VTG Series

FULTON Vantage VTG 6000DF

Preview: FULTON VMP40

Preview: FULTON VMP Series

FULTON VMP Series

Preview: FULTON VSRT Series

FULTON VSRT Series