1-7-1 HM410INT
HOW TO INITIALIZE THE VCR
To put the program back at the factory-default,
initialize the VCR as the following procedure.
1. Make sure that no timer programming is set. If not,
reset all timer programming.
2. Turn the power off.
3. Press the [STOP/EJECT] button and
[CHANNEL K] button on the unit simultaneously
for at least 2 seconds.
Upon completion of the initialization of the
EEPROM, ā ā mark on the display turns on a
light.
4. Release the [STOP/EJECT] button and
[CHANNEL K] button to complete this mode.
To Next Page
Loading...
