-6-
Bluetooth Adapter
Getting Started
Getting Started
Finding out preconditions
Basis-Set
In order to be able to use the Bluetooth Adapter, it is necessary to install the
Basis Set properly into your vehicle.
Therefore, it is important to select appropriate places for the
• electronic box,
•microphone and
• the cradle for the telephone holder or Bluetooth Adapter.
as well as for the connections to the
• electronic equipment,
• to the external antenna (not necessary for Bluetooth Adapter)
• car radio and if necessary, to the
• external additional loudspeaker.
In addition, if required, the additional noise suppression and/or the increased
volume should be activated.
The relevant instructions can be found in the basic set installation guide.
Vehicle
For getting started, the vehicle should be parked at a quiet place.Testing the
functions requires the ignition to be turned on and off, but the engine does not
have to be started.
It is advantageous to ask a conversation partner to assist you in making test calls.
The Bluetooth Adapter evaluates the ignition signal for its
operation. It remains on as long as the ignition is recognised as
switched on. On no account, may the ignition wire in the basic set
be connected to permanent battery voltage. If it is, the hands-free
speaking system will constantly discharge the battery whenever
the car is parked.
To Next Page
Loading...
