1
4
bintec User’s Guide System
System Menu
Location Indicates where your gateway is located.
Is shown, for example, on the HTML system
information page or in the login message.
Contact Indicates the responsible contact person. Here
you can enter the e-mail address of the system
administrator, for example.
Default value: BINTEC.
Is shown, for example, on the HTML system
information page.
Syslog Output on Serial
Console
Enables the display of syslog messages on the
PC connected to the serial interface of the
gateway. Use this setting only if you make a
fault analysis, as a very large output over the
serial console adversely affects the throughput
of the other interfaces.
You should normally use EXTERNAL SYSTEM
L
OGGING. Possible values:
■ yes
■ no (default value)
Field Description
To Next Page
Loading...
