Operation procedures (Breaking)
2 – 19
Storage after operation
CAUTION
The rod is hot right after hammering, so do not touch it.
When operation is suspended or completed
When operation is suspended or completed, move the base machine to a flat ground, remove mud
from the breaker body, and vertically lower the hydraulic breaker.
• Check for oil leakage from the piping and damage to the rod.
• When the breaker is used in a river, water might have entered not only the base machine but also
the inside of the breaker body. Dry them sufficiently, and grease the front head section.
To Next Page
Loading...