2-2
DJ-1
For MODEL1824C/1834C/1934C/1944C/1954C, remove the waterproofing cap from DJ-1
port and discard it.
MODEL1824C/1834C: Connect the MJ-B24LPF0002 cable from the antenna unit
to this port.
MODEL1934C/1944C/1954C: Connect the MJ-B24LPF0005 cable from the power supply
unit to this port.
GD-1920C: Do not remove the waterproofing cap.
Wrap the connector nut and cap with vinyl tape as shown
below.
Connector nut (for 24P)
Waterproofing cap (yellow)
Vinyl tape
Waterproofing cap and connector nut, sectional view
Ground terminal
Connect the ground wire (local supply, IV-2sq) between the ground terminal and ship’s
ground.
DATA1 to DATA4
Other equipments can be connected here as shown below.
DATA1 (7P) DATA2 (6P) DATA3 (6P) DATA4 (7P)
GPS receiver
GP-310B/320B
NMEA sentence
(ex. Navaid)
Heading sensor (ex. SC-60/120)
(MODEL series only)
External buzzer,
PC, NMEA IN (Echo
sounder)
This equipment can receive the following NMEA 0183 format sentence from other
equipments. You will need the optional NMEA cable to connect with external equipment.
•
Own ship’s position: GGA>RMC>RMA>GLL
•
Time: ZDA>RMC
•
Ship’s speed: RMC>RMA>VTG>VHW
•
Other ship’s information: TTM
•
Wind speed and angle: MWV>VWT/VWR
•
Heading (True): HDT>HDG>HDM>VHW
•
Heading (Magnetic HDM>HDG>HDT>VHW
•
Course: RMC>RMA>VTG
•
Depth: DPT>DBT>DBS>DBK
•
Waypoint RMB>WPL>BWR>BWC
•
Water temperature: MTW
•
Target data TLL (output from VHF radiotelephone FM-2721)
•
DSC information DSC>DSE (output from VHF marine transceiver FM-3000)
To Next Page
Loading...
