3-11
40. Choose item and press the EDIT soft key. Choose appropriate setting and then press
the ENTER soft key. Refer to the table and sentence description on the next page for
details.
41. Press the NEXT key, and the NMEA PORT menu appears. Set up this port similar to
how you set up the GPS/PORT menu.
OUTPUT FORMAT NMEA0183
Ver 2.0
BAUD RATE 4800bps
LAT/LON FORMAT DD'MM.MMM'
OUTPUT DESTINATION NO
Installation wizard, NMEA port setup
42. Press the NEXT key, and the NMEA PORT setup menu appears. Set up this port similar
to how you set up the GPS/NMEA port.
NMEA O
UTPUT FORMAT NMEA VER. 2.0
BAUD RATE 4800 bps
BIT LENGTH 8 bits
STOP BIT 1 bit
(CONTROL: Xon/Xoff)
Installation wizard, NMEA port setup
Description of items in “port” menus
Item Description Settings Default Setting
FURUNO GPS
Sensor
Selects whether the GPS Receiver
GP-310B/320B is connected to the
DATA1 or DATA2 port or not.
Yes, No Yes (DATA1)
No (DATA2)
Output Format
Selects NMEA output version for the
equipment connected.
NMEA0183 Ver. 1.5,
NMEA0183 Ver. 2.0
NMEA0183 Ver.
2.0
Baud Rate Sets baud rate.
(PC) 4800, 9600,
19800/(NMEA) Auto,
4800, 38400 bps
4800 bps
Lat/Lon Format
Selects latitude/longitude format to
output.
DD°MM.MM’,
DD°MM.MMM’,
DD°MM.MMMM’
DD°MM.MMM’
Output
Destination
Selects whether to output route (data
sentence RTE) and waypoint data (data
sentence WPL) when destination is set.
Yes, No No
PORT MNITR
(soft key)
Use this key to view which sentences are being output. See the example below.
$GPGLL,3415.2345,N,13520.5301,E,152500.00
,A*E7<CR><LF>$GPGLL,3415.2345,N,135
20.5301,E,152500.00,A*E7<CR><LF>$GPGLL
,3415.2345,N,13520.5301,E,152500.00,A*
E7<CR><LF>$GPGLL,3415.2345,N,13520.530
1,E,152500.00,A*E7<CR><LF>$GPGLL,3415.
2345,N,13520.5301,E,152500.00,A*E7<CR>
<LF>$GPGLL,3415.2345,N,13520.5301,E,15
2500.00,A*E7<CR><LF
Installation wizard, port monitor display
To Next Page
Loading...
