Furuno DFF-3D - Operation Check

3. INITIAL SETTINGS
3-3
3.2 Operation Check
After connecting the NavNet TZtouch/NavNet TZtouch2, power the unit on/off from the
ship’s switchboard. The LED on the cover of the DFF-3D lights or flashes according
to equipment state, as described in the table below.
LED state and meaning
LED state Meaning
Lit continuously Standby state. (If no signal is received via LAN for more
than 10 minutes, the equipment automatically goes into
standby to lessen power consumption.)
Blinking every two seconds Normal operation
㻸㻱㻰