What to do if Furuno DS-60 indication shows hyphens?
If your Furuno Sonar shows hyphens (-) at digit locations, it likely means the GPS receiver is disconnected. Check the GPS receiver to resolve this issue.
What to do if Furuno Sonar indication shows “-.--”?
If your Furuno Sonar's indication shows “-.--”, there may be a GPS data error. To fix this, check the GPS receiver.
Why Furuno Sonar power cannot be turned on?
If your Furuno Sonar's power cannot be turned on, first check the power cable to ensure it is securely fastened. If the cable is fine, a qualified technician should check the fuse in the display unit and replace it if blown.
What to do if Furuno DS-60 Sonar display has frozen?
If your Furuno Sonar indication does not change and the speed unit is red, it could be due to air bubbles on the transducer face. Wait for the air bubbles to disappear. Alternatively, if you're using ground tracking mode at a depth of 200 m or more, switch to water tracking mode or auto mode.
How to fix Furuno DS-60 Sonar black screen?
If the screen of your Furuno Sonar is black, the brilliance might be set too low. Try increasing the brilliance to see if that resolves the issue.
Step-by-step guide for powering the system on and off.
How to choose between ground, water, or auto tracking modes for speed measurement.
Introduction to the navigation data display and its components.
Detailed explanation of each data point shown on the navigation display.
Configuration options for navigation data settings.
Steps to set the time source, local time, and daylight saving.
Procedure to select the time display format (UTC or ship's time).
How to set the reference point for depth measurements.
How to configure the display for current direction (flow to/from).
How to select the display format for wind angle (Relative, True, Theoretical).
Configuring the maximum allowable speed alarm.
Introduction to the berthing display and its features for docking.
Settings related to the display range on the berthing screen.
Step-by-step guide to creating a new berthing line.
Explanation of the indicators and elements on the speed graphic display.
Routine checks for cables, cabinets, LCD, and transducers.
Information on parts that may need replacement.
Instructions and specifications for replacing fuses in various units.
Common problems, their possible causes, and recommended actions.
List of system error messages, their codes, and priority.
Procedures for diagnosing system and unit operational status.
Procedure for performing a system-wide operational test.
Guide for testing the functionality of the display unit.
How to test the LCD screen and its brilliance control circuit.
Steps to reset the equipment to its factory default settings.
General technical specifications including frequency, beams, and speed range.
Specifications for the main display unit, including LCD and brilliance.
Details on input/output signals and data sentence formats.
Electrical power requirements for the system.
Operating environmental limits such as temperature and humidity.
To Next Page
General
