Furuno DS-60 - How to Delete a Berthing Line

3. BERTHING DISPLAY
3-13
3.6.3 How to delete a berthing line
If you do not need a berthing line that you have made, you can delete the line as
shown below. The line is deleted from both the main and sub display units.
1. Press the MENU/ESC key to open the menu.
2. Select [Berthing Line] then press the ENT key.
3. Select [Delete] then press the ENT key to show the list of berthing lines.
4. Select the line to delete then press the ENT key. You are asked if you are sure to
delete the line.
5. Select [Yes] then press the ENT key.
6. Press the DISP key to close the menu.