Furuno FAR-2127 - Page 330

6.4 Error Messages
6-35
Table
6.4.4(2/2) List of OTHER ALARM Message
DEPTH
Displayed when water depth is less than the depth set in “[Menu] -> 7
-> 4:DEPTH MARK”.
XTE
Displayed when the cross track error is out of the range set in
“[Menu] -> 8 -> 5: NAV LINE WIDE”.
TARGET ALARM
Displayed when an applicable target enters or leaves the range set in
[ALARM1] and [ALARM2]. The setting of IN/OUT (Enter/Leave) is
made in “[Menu] -> 3 -> 2: TARGET ALARM MODE”.
Table 6.4.5 List of WORK IN PROGRESS Message
WORK IN PROGRESS Description
TUNE INITIALIZE Displayed when “[Menu] -> 1 -> 3: TUNE INITIALIZE” is executed.
PM
Displayed when “[Menu] -> 0 -> 4 -> 0: PM GAIN ADJ and [Menu]
-> 1 -> 4: PM” is executed.
Since the PM is turned on and automatically displays PM signals, the
setting of the range, pulse length and signal processing is optimized.
USER DEFAULT
Displayed when “[Menu] -> 9 -> 3, 4, 5, 6 -> 5: USER DEFAULAT”
is selected and the user setting registered to the FUNCTION key is
read out.
Note:
The user setting is registered by long pressing the FUNCTION key
and read out by short pressing the FUNCTION key.
SART
Displayed when “[Menu] -> 1 -> 5: SART” is executed. Since SART
signals are automatically displayed, the setting of the range, pulse
length and signal processing is optimized.
WR CARD DATA
Displayed when “[Menu] -> 6 -> 4～9: WR xx” is executed.
RD CARD DATA Displayed when “[Menu] -> 6 -> 3: READ CARD” is executed.
FORMAT CARD DATA Displayed when “[Menu] -> 6 -> 0 -> 3: INITIALIZE” is executed.
DELETE CARD DATA Displayed when “[Menu] -> 6 -> 0 -> 2: FILE DELETE” is executed.
CABLE ATT ADJ
Displayed when “AUTO” is executed in “[Menu] -> 0 -> 2 -> 2:
CABLE ATT ADJ”.
POWER ON RESET
Displayed when the operation of “[Menu] -> 6 -> 3 -> Ixxxxxx” is
performed. Read out of “9. WR INITIALIZE DATA”.