Furuno FAR-28x7 Series - Own Ship Symbol

1. RADAR OPERATION
1-89
01
02
03
04
05
06
07
08
09
10
1.48 Own Ship Symbol
Own ship symbol ( ) may be inscribed on the screen as below. You may enter
ten such symbols. Each own ship symbols is shown with a number.
1. Roll the trackball to choose the MARK box at the left side of the screen. The
guidance box now reads “MARK SELECT / MARK MENU.”
MARK 
Mark type last
selected, mark
number
-> +
- - -m, - - -m
1
Dimensions of
own ship
Mark box
2. Push the right button to open the MARK menu.
[MARK MENU]
1 ORIGIN MARK STAB
GND/SEA
2 MARK KIND
ORIGIN MARK(No. )/
ORIGIN MARK(SYM)/
MAP MARK/
WP 1~50/
WP 51~ 100/
WP 101~150/
WP 151~ 200/
OWN SHIP SHAPE
8 MARK POSN
CURSOR/OS/L/L
00°000.00 N
000°000.00 E
9 MAP DISPLAY
OFF/ON
0 MAP MARK COLOR*
RED/GRN/BLU/YEL/
CYA/MAG/WHT
* Not available on IMO
or A type
MARK menu
3. Roll the wheel to choose “2” and then push the wheel or the left button.
4. Roll the wheel to choose OWN SHIP SHAPE and then push the wheel or the
left button.
5. Push the right button to close the menu.
6. Use the trackball to choose the own ship symbol at the
bottom left corner.
7. Roll the wheel to choose the point number for which you
want to change its position. See figure at right.
8. Push the left button twice. The cursor positions at the point
number chosen.
9. Use the trackball to drag the point to location desired.
10. Push the left button to confirm chosen location.
11. Repeat steps 6-10 continue changing symbol shape.