Furuno felcom15 - Installation of Gps Receiver (Option)

20
4. INSTALLATION OF GPS RECEIVER
(OPTION)
A GPS receiver board can be installed in the terminal unit IC-215.
Name: GPS receiver
Type: OP16-24
Code No.: 004-438-940
Name Type Code No. Qty Remarks
Connector assy. 51065-0700-PHR7-L040 000-146-174 1 w/PH-7P
GPS receiver board GN-79L5A-N 000-146-179 1
Connector assy. H.FL-2LP-FHSB-A (100) 000-146-259 1 Mini pin
Pan head screw M2x4 000-803-232 2
Note: Use antistatic groves to treat items.
1. Attach connector assemblies (51065/0700-PHR7-L040 and H.FL-2LP-FHSB-A (100)) to
the GPS receiver board (GN-79L5A-N).
1. Attach the connector at right angle.
If not, connector pins may be bent.
2. After connecting connector assemblies, the load
on their cables should be as below.
less than 2.94N (300gf)
less than 2.94N (300gf)
less than 9.8N (1kgf)
How to treat connectors
Assembling GPS receiver
2. Unfasten 18 screws, six spacers, three nuts to remove the terminal unit cover.
www.reelschematic.com
www.reelschematic.com